Dell U2723QE Monitor Simplified Service Manual - Page 15
Self-Test
View all Dell U2723QE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
6. Trouble Shooting Instructions Self-Test Your monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly connected but the monitor screen remains dark, run the monitor self-test by performing the following steps: 1. Turn off both your computer and the monitor. 2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove all digital and the analog cables from the back of computer. 3. Turn on the monitor. The floating dialog box should appear on-screen (against a black background), if the monitor cannot sense a video signal and is working correctly. While in self-test mode, the power LED remains white. Also, depending upon the selected input, one of the dialogs shown below will continuously scroll through the screen. No DP Cable The display will go into Standby Mode in 4 minutes. www.dell.com/U3023E/U2723QE/U3223QE or No HDMI Cable The display will go into Standby Mode in 4 minutes. www.dell.com/U3023E/U2723QE/U3223QE or No USB-C Cable The display will go into Standby Mode in 4 minutes. www.dell.com/U3023E/U2723QE/U3223QE 4. This box also appears during normal system operation if the video cable becomes disconnected or damaged. 5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor. If your monitor screen remains blank after you use the previous procedure, check your video controller and computer, because your monitor is functioning properly.