Dell Vostro 230s Service Manual - Slim Tower - Page 21
Heat Sink and Processor - vostro 230 supported processors
View all Dell Vostro 230s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Back to Contents Page Heat Sink and Processor Dell™ Vostro™ 230s Service Manual-Slim Tower WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. Removing the Heat Sink and Processor NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below. 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the cover. 3. Remove the chassis support bracket. 4. Disconnect the heat sink cable from the system board. 5. Loosen the captive screws that secure the heat sink and fan assembly to the system board. 6. Lift the heat sink assembly and remove it from the computer. Lay the assembly on a clean work surface with the fan facing downward and the bottom facing upward. 7. Press down and slide the lever to release the processor cover. 8. Lift the processor cover. 9. Carefully lift and remove the processor from its socket, and place it into an antistatic package. Replacing the Heat Sink and Processor To replace the heat sink and processor, perform the above steps in reverse order. Back to Contents Page