Dell Vostro 5502 Service Manual - Page 58

Installing the display assembly

Get Dell Vostro 5502 PDF manuals and user guides View all Dell Vostro 5502 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 58 highlights

Steps 1. Locate the display cable and display hinges on your computer. 2. Peel the tape that secures the display cable to the system board. 3. Open the latch, and disconnect the display cable from the system board. 4. Remove the three screws (M2.5x3.5) that secure the left-display hinge to the system board. 5. Remove the three screws (M2.5x3.5) that secure the right-display hinge to the system board. 6. Open the display hinges at an angle of 90 degrees. 7. Slide the palm-rest and keyboard assembly off the display assembly carefully. Installing the display assembly Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The figure indicates the location of the component and provides a visual representation of the installation procedure. 58 Disassembly and reassembly

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
Steps
1.
Locate the display cable and display hinges on your computer.
2.
Peel the tape that secures the display cable to the system board.
3.
Open the latch, and disconnect the display cable from the system board.
4.
Remove the three screws (M2.5x3.5) that secure the left-display hinge to the system board.
5.
Remove the three screws (M2.5x3.5) that secure the right-display hinge to the system board.
6.
Open the display hinges at an angle of 90 degrees.
7.
Slide the palm-rest and keyboard assembly off the display assembly carefully.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the component and provides a visual representation of the installation procedure.
58
Disassembly and reassembly