Dell W-7024 Controller Installation Guide - Page 12

l STATUS- Placed on the top right of the port, this LED displays the status of the port. The information displayed by this LED changes based on the LCD mode. The LED behavior corresponding to each LCD mode is listed in Table 6. Table 6: 10GBASE-X Port LEDs LED Function LCD Mode Indicator Status LINK/ACT Link status NA Green (Solid) Link established Green (Blinking) Port is transmitting or receiving data Off No link STATUS Port status Administrative Green (Solid) Port enabled Off Port administratively disabled Duplex Green (Solid) Full-duplex Off NA Speed Green (Solid) 10 Gbps Off 1 Gbps SFP/SFP+ Modules and DAC Cables SFP/SFP+ modules, also known as mini-GBICs, are hot-swappable and provide optical or copper connections to other devices. Direct attach cables (DACs) are installed in an uplink port in the same manner as an SFP/SFP+ module. For the list of Dell approved DAC cables and SFP/SFP+ modules for controllers, see Table 7 and Table 8. NOTE: Other non-approved third-party optics or DAC cables are not tested or supported by Dell on controllers; therefore, Dell does not guarantee their proper functionality when used with Dell controllers. For information on how to install an SFP/SFP+ module or a DAC cable, see "Installing an SFP/SFP+ Module" on page 25. Table 7: Supported DAC Cables DAC Description DAC-SFP-10GE-50CM 50cm Direct Attach Cable; 10G SFP+ DAC-SFP-10GE-1M 1m Direct Attach Cable; 10G SFP+ DAC-SFP-10GE-3M 3m Direct Attach Cable; 10G SFP+ DAC-SFP-10GE-5M 5m Direct Attach Cable; 10G SFP+ DAC-SFP-10GE-7M 7m Direct Attach Cable; 10G SFP+ Dell Networking W-7024 Controller | Installation Guide W-7024 Controller | 12