Dell W-7024 Controller Installation Guide - Page 17

Figure 6: RJ-45 (Female) to DB9 (Male) Modular Adapter Conversion RJ-45 Female Pin-Out 1 2 3 TxD 4 5 GND 6 RxD 7 8 Internal Connections RJ-45 3 TxD 4 5 GND 6 RxD DB-9 2 5 3 DB-9 Male Pin-Out 9 8 7 6 5 Ground 4 3 RxD 2 TxD 1 Micro-USB Console Port The W-7024 controller is equipped with one Micro-USB (type B) connector on the back panel of the controller that provides console access for direct local access. If both Micro-USB and RJ-45 Console ports are connected, the MicroUSB connection takes precedence over the RJ-45 Console connection. Micro-USB Driver To use the Micro-USB console port, install the Dell Micro-USB driver on the system that will manage the controller. The driver is available on download.dell-pcw.com under Tools & Resources. Power Supply The W-7024 controller is equipped with an integrated AC power supply of 580W. The integrated power supply supports 400W of PoE power and 180W of system power. Grounding Point To meet safety and electromagnetic interference (EMI) requirements and to ensure proper operation, the controller must be adequately grounded before power is connected. Connect a grounding cable to earth ground and then attach it to the chassis grounding point using two screws. Comply with electrical grounding standards during all phases of installation and operation of the product. Do not allow the controller's chassis, network ports, power supply, or mounting brackets to contact any device, cable, object, or person attached to a different electrical ground. Also, never connect the device to external storm grounding sources. 17 | W-7024 Controller Dell Networking W-7024 Controller | Installation Guide