Dell W-7024 Controller Installation Guide - Page 28

CLASS 1 LASER PRODUCT CAUTION: Use of controls or adjustments of performance or procedures other than those specified in this manual may result in hazardous radiation exposure. ATTENTION: L'utilisation de commandes ou de réglages de performances ou de procédures qui ne sont pas spécifiées dans ce manuel risque d'entraîner une exposition à des rayonnements dangereux. This product complies with 21 CFR Chapter 1, Subchapter J, Part 1040.10, and IEC 60825-1: 1993, A1: 1997, A2: 2001, IEC 60825-2: 2004+A1. For continued compliance with the above laser safety standards, only approved Class 1 modules from our approved vendors should be installed in the product. CAUTION: Although this controller has been tested up to 1 kV per CE immunity requirements, this product requires surge protection to be provided as part of the building installation to protect against unidirectional surges resulting from electrical switching and lightning strikes. For protection against these surges in an outdoor installation, any exposed wiring must be shielded, and the shield for the wiring must be grounded at both ends. ATTENTION: Le contrôleur a été testé jusqu'à 1 000 V conformément aux exigences en matière d'immunité de la Communauté européenne. Cependant, il est essentiel de prévoir une protection contre les surtensions dans l'installation électrique du bâtiment afin de protéger l'appareil contre les surtensions unidirectionnelles provenant du circuit électrique ou de la foudre. Pour se protéger contre ces surtensions dans une installation extérieure, tous les câbles exposés doivent être blindés et le blindage doit être mis à la terre aux deux extrémités. Regulatory Model Name The regulatory model name for the W-7024 controller is ARCN7024. Electromagnetic Interference United States FCC Class A This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. 28 | Specifications, Safety, and Compliance Dell Networking W-7024 Controller | Installation Guide