Dell W-7024 Controller Installation Guide - Page 20

Installation Steps, Rack Mount Installation- Mid

Get Dell W-7024 PDF manuals and user guides View all Dell W-7024 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Installation Steps To install a W-7024 controller from the front in a standard two-post 19-inch Telco rack: 1. Place the mounting brackets over the mounting holes on either side of the controller towards the front (see Figure 7). Figure 7: Rack Mounting Brackets 2. Secure the brackets to the controller using the eight screws for the mounting bracket (four per bracket) and a suitable screwdriver. 3. If the rack requires cage nuts or clip nuts, insert them on the front rails (two per rail, aligned horizontally). 4. Mount the controller in the rack using the four screws for system rack mount (two per bracket) and a suitable screwdriver (see Figure 8). Figure 8: Front-Rack Mount Installation NOTE: Leave a minimum of 10 cm (4 inches) of space on the left and right side of the controller for proper air flow and ventilation. Leave additional space in the front and the back of the controller to access network cables, LED status indicators, and power cord. Rack Mount Installation- Mid An optional accessory kit (SPR-WL2-MNT, must be purchased separately) allows mounting the W-7024 controller from the middle in a standard 19-inch Telco rack. CAUTION: Each W-7024 controller must have its own mounting equipment. Do not place other networking equipment directly on top of a mounted W-7024 controller. Failure to do so can damage the controller. Dell Networking W-7024 Controller | Installation Guide Installation | 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
Installation Steps
To install a W-7024 controller from the front in a standard two-post 19-inch Telco rack:
1.
Place the mounting brackets over the mounting holes on either side of the controller towards the front (see
Figure 7
).
Figure 7:
Rack Mounting Brackets
2.
Secure the brackets to the controller using the eight screws for the mounting bracket (four per bracket) and a
suitable screwdriver.
3.
If the rack requires cage nuts or clip nuts, insert them on the front rails (two per rail, aligned horizontally).
4.
Mount the controller in the rack using the four screws for system rack mount (two per bracket) and a suitable
screwdriver (see
Figure 8
).
Figure 8:
Front-Rack Mount Installation
NOTE:
Leave a minimum of 10 cm (4 inches) of space on the left and right side of the controller for proper air flow and ventilation.
Leave additional space in the front and the back of the controller to access network cables, LED status indicators, and power cord.
Rack Mount Installation- Mid
An optional accessory kit (SPR-WL2-MNT, must be purchased separately) allows mounting the W-7024 controller
from the middle in a standard 19-inch Telco rack.
CAUTION: Each W-7024 controller must have its own mounting equipment. Do not place other networking equipment directly on top
of a mounted W-7024 controller. Failure to do so can damage the controller.
Dell Networking W-7024 Controller |
Installation Guide
Installation | 20