Dell W-Series 324 Instant 6.5.1.0-4.3.1.0 User Guide - Page 20
Accessing the Instant CLI, Specifying Country Code, Connecting to a CLI Session
View all Dell W-Series 324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Improper country code assignments can disrupt wireless transmissions. Most countries impose penalties and sanctions on operators of wireless networks with devices set to improper country codes. To view the country code information, run the show country-codes command. Specifying Country Code This procedure is applicable only to the W-IAP-RW variants. Skip this step if you are installing W-IAP in the United States and Japan. The Country Code window is displayed for the W-IAP-RW variants when you log in to the W-IAP UI for the first time. The Please Specify the Country Code drop-down list displays only the supported country codes. If the W-IAP cluster consists of multiple W-IAP platforms, the country codes supported by the master W-IAP is displayed for all other W-IAPs in the cluster. Select a country code from the list and click OK. The W-IAP operates in the selected country code domain. Figure 2 Specifying a Country Code . You can also view the list of supported country codes for the W-IAP-RW variants using the show countrycodes command. Accessing the Instant CLI Instant supports the use of Command Line Interface (CLI) for scripting purposes. When you make configuration changes on a master W-IAP in the CLI, all associated W-IAPs in the cluster inherit these changes and subsequently update their configurations. By default, you can access the CLI from the serial port or from an SSH session. You must explicitly enable Telnet access on the W-IAP to access the CLI through a Telnet session. For information on enabling SSH and Telnet access to the W-IAP CLI, see Terminal access on page 60. Connecting to a CLI Session On connecting to a CLI session, the system displays its host name followed by the login prompt. Use the administrator credentials to start a CLI session. For example: User: admin If the login is successful, the privileged command mode is enabled and a command prompt is displayed. For example: (Instant AP)# The privileged EXEC mode provides access to show, clear, ping, traceroute, and commit commands. The configuration commands are available in the config mode. To move from Privileged EXEC mode to the Configuration mode, enter the following command at the command prompt: (Instant AP)# configure terminal Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide Setting up a W-IAP | 20