Dell W-Series 324 Instant 6.5.1.0-4.3.1.0 User Guide - Page 254
Customize Valid Channels, Minimum, Transmit Power, Enabled, Disabled, Wide Channel Bands, Table 56
![]() |
View all Dell W-Series 324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 254 highlights
Table 56: Access Point Control-Configuration Parameters Parameter Description Customize Valid Channels Select this check box to customize valid channels for 2.4 GHz and 5 GHz. By default, the W-IAP uses valid channels as defined by the Country Code (regulatory domain). On selecting the Customize Valid Channels check box, a list of valid channels for both 2.4 GHz and 5 GHz are displayed. The valid channel customization feature is disabled by default. Minimum Transmit Power Specify the minimum transmission power. The value specified for Minimum Transmit Power indicates the minimum Effective Isotropic Radiated Power (EIRP) that can range from 3 dBm to 33 dBm in 3 dBm increments. If the minimum transmission EIRP setting configured on a W-IAP is not supported by the W-IAP model, this value is reduced to the highest supported power setting. The default value for minimum transmit power is 18 dBm. Maximum Transmit Power Specify the maximum transmission power. The value specified for Maximum Transmit Power indicates the maximum Effective Isotropic Radiated Power (EIRP) that can range from 3 dBm to 33 dBm in 3 dBm increments. If the maximum transmission EIRP configured on a W-IAP is not supported by the WIAP model, the value is reduced to the highest supported power setting. The default value for maximum transmit power is 127 dBm. Client aware When Enabled, ARM does not change channels for the W-IAPs with active clients, except for high-priority events such as RADAR or excessive noise. This feature must be enabled in most deployments for a stable WLAN. If the Client Aware mode is Disabled, the W-IAP may change to a more optimal channel, that may disrupt the current client traffic for a while. The Client aware option is Enabled by default. NOTE: When Client aware is disabled, channels can be changed even when the clients are active on a BSSID. Scanning Select Enabled so that the W-IAP dynamically scans all 802.11 channels within its 802.11 regulatory domain at regular intervals and reports to the W-IAP. This scanning report includes WLAN coverage, interference, and intrusion detection data. NOTE: For client match configuration, ensure that scanning is enabled. Wide Channel Bands Select a band to allow the W-IAPs to be placed in 40 MHz (wide band) channels. The Wide Channel Bands allows administrators to configure 40 MHz channels in the 2.4 GHz and 5 GHz bands. 40 MHz channels are two 20 MHz adjacent channels that are bonded together. A 40 MHz channel effectively doubles the frequency bandwidth available for data transmission. 80 MHz Support Enables or disables the use of 80 MHz channels on W-IAPs. This feature allows ARM to assign 80 MHz channels on W-IAPs with 5 GHz radios, which support a very high throughput. This setting is enabled by default. NOTE: Only the W-IAPs that support 802.11ac can be configured with 80 MHz channels. 2. Reboot the W-IAP. 254 | Adaptive Radio Management Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide
![](/manual_guide/products/dell-wseries-324-instant-65104310-user-guide-8f98e93/254.png)