Dell W-Series 324 Instant 6.5.1.0-4.3.1.0 User Guide - Page 60
Access Points, Enabled, Disabled, Extended SSID, Deny inter user bridging
![]() |
View all Dell W-Series 324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Table 17: System Parameters Parameter Auto join mode Terminal access Console access Telnet server LED display Extended SSID Deny inter user bridging Description CLI Configuration The Auto-Join feature allows W-IAPs to automatically discover the VC and join the network. The Auto-Join feature is enabled by default. If the Auto-Join feature is disabled, a link is displayed in the Access Points tab indicating that there are new W-IAPs discovered in the network. Click this link if you want to add these W-IAPs to the network. When Auto-Join feature is disabled, the inactive WIAPs are displayed in red. To disable auto-join mode: (Instant AP)(config) # no allow-new-aps To enable auto-join mode: (Instant AP)(config) # allow-new-aps When terminal access is enabled, you can access the W-IAP CLI through SSH. The terminal access is enabled by default (Instant AP)(config) # terminal-access When enabled, you can access the W-IAP through the console port. (Instant AP)(config) # console To start a Telnet session with the W-IAP CLI, enable access to the Telnet server. (Instant AP)(config) # telnet-server LED display status of the W-IAP. To enable or disable LED display for all W-IAPs in a cluster, select Enabled or Disabled, respectively. NOTE: The LEDs are always enabled during the WIAP reboot. (Instant AP)(config) # led-off Extended SSID is enabled by default in the factory default settings of W-IAPs. This disables mesh in the factory default settings. l The W-IAP108/109 access points support up to 6 SSIDs with Extended SSID disabled and up to 8 SSIDs with Extended SSID enabled. l All other W-IAPs support up to 14 SSIDs when Extended SSID is disabled and up to 16 SSIDs with Extended SSID enabled. (Instant AP)(config) # extended-ssid If you have security and traffic management policies defined in upstream devices, you can disable bridging traffic between two clients connected to the same W-IAP on the same VLAN. When inter user bridging is denied, the clients can connect to the Internet but cannot communicate with each other, and the bridging traffic between the clients is sent to the upstream device to make the forwarding decision. By default, the Deny inter user bridging parameter is disabled. (Instant AP)(config) # deny-inter-userbridging To disable inter-user bridging for the WLAN SSID clients: (Instant AP)(config) # wlan ssid-profile Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide Initial Configuration Tasks | 60
![](/manual_guide/products/dell-wseries-324-instant-65104310-user-guide-8f98e93/60.png)