Dell W-Series 324 Instant 6.5.1.0-4.3.1.0 User Guide - Page 409
Aruba GRE configuration, Per-AP GRE tunnel configuration, Centralized, L2 DHCP profile VLAN 20
View all Dell W-Series 324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 409 highlights
W-IAP Configuration This section provides information on configuration steps performed by using the CLI and the UI. Table 87: W-IAP Configuration for Scenario-GRE: Single Datacenter Deployment with No Redundancy Configuration Steps CLI Commands UI Procedure 1. Configure Aruba GRE or manual GRE l Aruba GRE uses an IPsec tunnel to facilitate controller configuration and requires VPN to be configured. This VPN tunnel is not used for any client traffic. l Manual GRE uses standard GRE tunnel configuration and requires controller configuration to complete the GRE tunnel. Aruba GRE configuration (Instant AP)(config)# vpn primary (Instant AP)(config)# vpn gre-outside Manual GRE configuration (Instant AP)(config)# gre primary (Instant AP)(config)# gre type 80 Per-AP GRE tunnel configuration Optionally, per-AP GRE tunnel can also be enabled, which causes each W-IAP to form an independent GRE tunnel to the GRE endpoint. Aruba GRE requires each W-IAP MAC to be present in the controller whitelist. Manual GRE requires GRE configuration for the IP of each W-IAP on the controller. (Instant AP)(config)# gre per-ap-tunnel See Configuring Aruba GRE Parameters and Configuring Manual GRE Parameters 2. Configure routing profiles to tunnel traffic through GRE. NOTE: Starting with Instant 6.5.1.0-4.3.1.0, if VC IP is configured and per-AP GRE tunnel is disabled, W-IAP uses VC IP as the GRE source IP. For Manual GRE, this simplifies configuration on controller, since only the VC IP destined GRE tunnel interface configuration is required. (Instant AP)(config)# routing-profile (Instant AP)(routing-profile)# route 0.0.0.0 0.0.0.0 3. Configure Enterprise DNS. The example in the next column tunnels all DNS queries to the client's original DNS server without proxying on W-IAP. (Instant AP)(config)# internal-domains (Instant AP)(domains)# domain-name * 4. Configure Centralized, L2 DHCP profile with VLAN 20. Centralized, L2 DHCP profile VLAN 20 (Instant AP)(config)# ip dhcp l2-dhcp (Instant AP)(DHCP profile "l2-dhcp")# server-type Centralized,L2 (Instant AP)(DHCP profile "l2-dhcp")# server-vlan 20 See Configuring Routing Profiles See Configuring Enterprise Domains See Configuring Centralized DHCP Scopes Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide IAP-VPN Deployment Scenarios | 409