Dell W-Series 324 Instant 6.5.1.0-4.3.1.0 User Guide - Page 231
More > VPN, Tunneling, L2TPv3, Protocol,
![]() |
View all Dell W-Series 324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
l If the primary LNS is down, it fails over to the backup LNS. L2TPv3 has one tunnel profile, and under this a primary peer and a backup peer are configured. If the primary tunnel creation fails or if the primary tunnel gets deleted, the backup starts. The following two failover modes are supported: n Preemptive: In this mode, if the primary comes up when the backup is active, the backup tunnel is deleted and the primary tunnel resumes as an active tunnel. If you configure the tunnel to be preemptive, and when the primary tunnel goes down, it starts the persistence timer which tries to bring up the primary tunnel. n Non-Preemptive: In this mode, when the backup tunnel is established after the primary tunnel goes down, it does not make the primary tunnel active again. L2TPV3 is not supported on W-IAP205 devices. You can configure an L2TPv3 tunnel and session profiles through the Instant UI or the CLI. In the Instant UI To configure an L2TPv3 tunnel and session profile: 1. Click the More > VPN link located directly above the Search bar in the Instant UI. The Tunneling window is displayed. Figure 54 L2TPv3 Tunneling 2. Select L2TPv3 from the Protocol drop-down list. 3. To configure the tunnel profile: a. Click the New button. b. Enter the tunnel name to be used for tunnel creation. 231 | VPN Configuration Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide
![](/manual_guide/products/dell-wseries-324-instant-65104310-user-guide-8f98e93/231.png)