Dell W-Series 324 Instant 6.5.1.0-4.3.1.0 User Guide - Page 69

2. In the Edit Access Point window, select Installation Type to configure the installation type for the W-IAP you have selected. Note that, by default, the Default mode is selected. This means that the W-IAP installation type is based on the W-IAP model. 3. You can either select the Indoor option to change the installation to Indoor mode or select the Outdoor option to change the installation to Outdoor mode. the to Outdoor mode. 4. Click OK. A pop-up appears on the screen indicating the W-IAP needs to be rebooted for the changes to take effect. 5. Click OK. In the CLI To configure the Installation Type: (Instant AP)# ap-installation To view the installation type of the W-IAPs: (Instant AP)# show ap allowed-channels Changing USB Port Status The USB port can be enabled or disabled based on your uplink preferences. If you do not want to use the cellular uplink or 3G/4G modem in your current network setup, you can set the USB port status to disabled. By default, the USB port status is enabled. You can change the USB port status by using the Instant UI or the CLI. In the Instant UI To change the USB port status: 1. From the Access Points tab, click the W-IAP to modify. 2. Click the edit link. 3. Click the Uplink tab. 4. Set the port status by selecting any of the following options: l Disabled-To disable the port status. l Enabled-To re-enable the port status. 5. Click OK. 6. Reboot the W-IAP. In the CLI To disable the USB port: (Instant AP)# usb-port-disable To re-enable the USB port: (Instant AP)# no usb-port-disable To view the USB port status: (Instant AP)# show ap-env Antenna Type:External usb-port-disable:1 Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide Customizing W-IAP Settings | 69