Dell XPS 13 Plus 9320 XPS 13 Plus 9320 / XPS 9320 Service Manual - Page 32

Close the display assembly, turn the computer over and place it on the flat surface.

Get Dell XPS 13 Plus 9320 PDF manuals and user guides View all Dell XPS 13 Plus 9320 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Steps 1. Open the display assembly to a 90-degree angle and place the computer on the edge of a flat surface. 2. Place the palm-rest and keyboard assembly at the edge of a flat table. 3. Open the hinges of the display assembly to a 90-degree angle. 4. Align the screw holes of the palm-rest and keyboard assembly to the screws holes on the hinges of the display assembly. 5. Replace the three screws (M2.5x5) that secure the left hinge to the palm-rest and keyboard assembly. 6. Replace the three screws (M2.5x5) that secure the right hinge to the palm-rest and keyboard assembly. 7. Close the display assembly, turn the computer over and place it on the flat surface. 8. Slide the camera and display-assembly cables holder back to the system board. 9. Replace three screws (M1.6x2.5) that secure the camera and display-assembly cables holder to the system board. 10. Connect the camera cable and the display cable to the system board. 32 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
Steps
1.
Open the display assembly to a 90-degree angle and place the computer on the edge of a flat surface.
2.
Place the palm-rest and keyboard assembly at the edge of a flat table.
3.
Open the hinges of the display assembly to a 90-degree angle.
4.
Align the screw holes of the palm-rest and keyboard assembly to the screws holes on the hinges of the display assembly.
5.
Replace the three screws (M2.5x5) that secure the left hinge to the palm-rest and keyboard assembly.
6.
Replace the three screws (M2.5x5) that secure the right hinge to the palm-rest and keyboard assembly.
7.
Close the display assembly, turn the computer over and place it on the flat surface.
8.
Slide the camera and display-assembly cables holder back to the system board.
9.
Replace three screws (M1.6x2.5) that secure the camera and display-assembly cables holder to the system board.
10.
Connect the camera cable and the display cable to the system board.
32
Removing and installing components