Denon AVR 1603 Owners Manual - Page 13

ENGLISH 11 REMOTE CONTROL UNIT Operating DENON audio components • Turn on the power of the different components before operating them. 1 Set mode switch 1 to "AUDIO". 2 Set mode switch 2 to the position for the component to be operated. (CD, CDR/MD or Tape deck) 3 1 2 3 Preset memory DENON and other makes of components can be operated by setting the preset memory. This remote control unit can be used to operate components of other manufacturers without using the learning function by registering the manufacturer of the component as shown on the List of Preset Codes (pages 192~194). Operation is not possible for some models. 1 Set mode switch 1 to "AUDIO" or "VIDEO". 3 Set the AUDIO side for the CD, Tape deck or CDR/MD position, to the VIDEO side for the DVD/VDP, DBS/CABLE, VCR or TV position. 2 Set mode switch 2 to the component to be registered. 4 1 2 3 Operate the audio component. • For details, refer to the component's operating instructions. While this remote control is compatible with a wide range of infrared controlled components, some models of components may not be operated with this remote control. 1. CD player (CD) and CD recorder and MD recorder (CDR/MD) system buttons 2. Tape deck (TAPE) system buttons 3 Press the ON/SOURCE button and the OFF button at the same time. 6,7 2 1 8,9 3 DISC SKIP+ : Manual search (reverse and forward) : Stop : Play : Auto search (Cue) : Pause : Switch discs (for CD changers only) 3. Tuner system buttons 6 : Rewind 7 : Fast-forward 2 : Stop 1 : Forward play 0 : Reverse play A/B : Switch between decks A and B SHIFT CHANNEL +, - TUNING +, - BAND MODE MEMORY : Switch preset channel range : Preset channel (up/down) : Frequency (up/down) : Switch between the AM and FM bands : Switch between auto and mono : Preset memory NOTE: • TUNER can be operated when the switch is at "AUDIO" position. • Indicator flash. 4 1 2 3 4 5 6 7 8 9 0 Referring to the included List of Preset Codes, use the number buttons to input the preset code (a 3-digit number) for the manufacturer of the component whose signals you want to store in the memory. 5 To store the codes of another component in the memory, repeat steps 1 to 4. NOTES: • The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control unit's transmitting window while setting the preset memory. • Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed on the included list of preset codes. • Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and check. • The preset memory can be set for one component only among the following: CDR/MD, DVD/VDP and DBS/CABLE. The preset codes are as follows upon shipment from the factory and after resetting: TV, VCR HITACHI CD, TAPE DENON CDR/MD DENON (CDR) DVD/VDP DENON (DVD) DBS/CABLE ABC (CABLE) 13