Denon AVR 1603 Owners Manual - Page 19

ENGLISH 2 Select the Dolby Surround Pro Logic II mode. 7 Set the various surround parameters. • CINEMA EQ setting CINEMA EQ OFF (Main unit) (Remote control unit) • The Dolby Pro Logic indicator lights. Display Light OFF or • PANORAMA setting ON or PANORAMA OFF 3 Play a program source with the mark. • For operating instructions, refer to the manuals of the respective components. OFF or ON or • DIMENSION setting DIMENSION 3 4 Select the surround parameter mode. Display MODE cinema (Main unit) (Remote control unit) To perform this operation from the remote control unit, check that the mode selector switch is set to "AUDIO". 5 Select the optimum mode for the source. 0 3 6 or or • CENTER WIDTH setting CENTER WIDTH O 0 4 7 or or • DEFAULT setting DEFAULT Y/N (Main unit) (Remote control unit) MODE emulation MODE cinema MODE music or or YES Y/N NO or or Select "Yes" to reset to the factory defaults. 6 8 Set the surround parameters according to the mode. Press the ENTER button to finish surround parameter mode. Surround parameters q Pro Logic II Mode: The Cinema mode is for use with stereo television shows and all programs encoded in Dolby Surround. The Music mode is recommended as the standard mode for autosound music systems (no video), and is optional for A/V systems. The Emulation mode offers the same robust surround processing as original Pro Logic in case the source contents is not of optimum quality. Select one of the modes ("Cinema", "Music" or "Emulation"). Panorama Control: This mode extends the front stereo image to include the surround speakers for an exciting "wraparound" effect with side wall imaging. Select "OFF" or "ON". Dimension Control: This control gradually adjust the soundfield either towards the front or towards the rear. The control can be set in 7 steps from 0 to 6. Center Width Control: This control adjust the center image so it may be heard only from the center speaker; only from the left/right speakers as a phontom image; or from all three front speakers to varying degrees. The control can be set in 8 steps from 0 to 7. Dolby Digital mode (only with digital input) and DTS Surround (only with digital input) 1 Select the input source. Playback with a digital input q Select an input source set to digital (COAXIAL/ OPTICAL) (see page 12). Example: 1 13 2 (Main unit) (Remote control unit) w Set the input mode to "AUTO" or "DTS". 2 (Main unit) (Remote control unit) 2 Select the Dolby/DTS Surround mode. 1 (Main unit) (Remote control unit) • The mode switches as shown below each time the button is pressed. MODE EMULATION CINEMA EQ DEFAULT MODE CINEMA CINEMA EQ DEFAULT MODE MUSIC PANORAMA DIMENSION CENTER WIDTH DEFAULT (Remote control unit) NOTE: • When making parameter settings, the display will return to the regular condition several seconds after the last button was pressed and the setting will be completed. (Main unit) (Remote control unit) 3 Play a program source with the mark. , DIGITAL Light • The Dolby Digital indicator lights when playing Dolby Digital sources. • The DTS indicator lights when Light playing DTS sources. 9 5, 6, 7, 8 1 4, 5, 6, 7, 8 5, 6, 7, 8 5, 6, 7, 8 19