Denon AVR-1613 Owners Manual - Page 28
Error messages - won t turn on
View all Denon AVR-1613 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Basic version Advanced version Information Error messages Set up speakers (Audyssey® Setup) NOTE • An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error message is displayed, check the relevant items and perform the necessary measures. Then perform Audyssey® Setup again. • If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker connections and repeat the measurement process from the beginning. • Be sure to turn off the power before checking speaker connections. Examples Audyssey Setup Caution! Microphone or Speaker is none Please check the cable connection and retry. MultEQ Error details • The connected setup microphone is broken, or a device other than the supplied setup microphone is connected. • Not all speakers could be detected. • A front speaker (left) was not properly detected. Measures • Connect the included setup microphone to the SETUP MIC jack of this unit. • Check the speaker connections. Retry Audyssey Setup Caution! MultEQ Ambient noise is too high or level is too low • There is too much noise in the room for accurate measurements to be made. • Speaker or subwoofer sound is too low for accurate measurements to be made. • Either turn off any device generating noise or move it away. • Perform again when the surroundings are quieter. • Check the speaker installation and the direction in which the speakers are facing. • Adjust the subwoofer's volume. Retry Audyssey Setup Speaker Not found Error... Front R Please check the cable connection and retry. MultEQ Retry Audyssey Setup Speaker Phase Error... Front R Please check the cable connection and retry. MultEQ Retry Phase Info. Skip • The displayed speaker could not be detected. (The screen on the left indicates that the front right speaker cannot be detected.) • Check the connections of the displayed speaker. • The displayed speaker is connected with the polarity reversed. (The screen on the left indicates that the polarity phases of the front right speakers are reversed.) • Check the polarity of the displayed speaker. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure the connection is correct, use o p to select "Skip", then press ENTER. 25