Denon AVR-2106 Owners Manual - Page 21

Connecting Other Sources ZONE2 speaker out connections • When the power amplifier is assigned to the ZONE2 output channel at "Power Amp Assign." in the "System Setup" menu, the surround back speaker terminals can be used as the ZONE2 speaker out terminals ( page 38). • The connections diagram below is an example for when the surround back speaker is assigned to the ZONE2 stereo 2 channel. In this case, surround back speaker out can not be used for MAIN ZONE. Subwoofer Center speaker Surround speaker systems IN Connection terminal for a subwoofer with built-in amplifier. >< (L) (R) > < ENGLISH Connecting Other Sources Connecting the pre-out terminals • Use these terminals if you wish to connect external power amplifier(s) to increase the power of the front, center, surround and surround back sound channels, or for connection to powered loudspeakers. • When using only one surround back speaker, connect it to the left channel. Power amplifier B CENTER A SURROUND L L L R R R A SURROUND BACK L L L R R R B SUB- WOOFER A FRONT L L L R R R (L) (R) >< Front speaker systems (B) (L) (R) >< Front speaker systems (A) Connecting the power supply cord AC outlets (Wall) AC 120 V, 60 Hz (L) (R) > < ZONE2 speaker systems NOTE: • The settings must be changed to use this speaker for ZONE2 ( page 47). AC OUTLETS • SWITCHED (total capacity - 120 W (1 A.)) The power to these outlets is turned on and off in conjunction with the POWER switch on the main unit, and when the power is switched between on and standby from the remote control unit. No power is supplied from these outlets when this unit's power is at standby. Never connect equipment whose total power consumption exceeds 120 W (1 A.). NOTE: • Only use the AC OUTLETS for connecting audio equipment. Never use it for hair driers, TVs or other electrical appliances. 18 ENGLISH