Denon AVR-2106 Owners Manual - Page 53

ENGLISH Advanced Setup - Part 2 • To cancel the settings, press the CURSOR H button to select "Level Clear" on the "Channel Level" screen, then make the settings again. • When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer's own volume control. • When you adjust the channel levels while in the system setup channel level mode, the channel level adjustments made will affect all surround modes. Consider this mode a master channel level adjustment mode. • After you have completed the system setup channel level adjustments, you can then activate the individual surround modes and adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode, your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each surround mode ( page 29). 2 Adjusting the test tone • Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment can be performed with the system setup ( page 49, 50) or from the remote control unit, as described below. • Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only effective in the STANDARD (DOLBY/DTS SURROUND) modes. The adjusted levels for the different modes are automatically stored in the memory. Setting the Crossover Frequency Set the crossover frequency mode according to the speaker system being used. 1 Press the CURSOR D or H button to select "Crossover Frequency" at the "Speaker Setup" menu, then press the ENTER button. • The "Crossover Frequency" screen appears. 2 Press the CURSOR F or G button to select the frequency. 40 / 60 / 80 / 100 / 120 / 150 / 200 / 250 Hz can be selected. 3 Press the ENTER button to enter the setting. • The "Speaker Setup" menu appears. Advanced Setup - Part 2 Setting the SW Mode Setup Set the subwoofer mode according to the speaker system being used. 1 Press the CURSOR D or H button to select "SW Mode Setup" at the "Speaker Setup" menu, then press the ENTER button. • The "Subwoofer Mode Setup" screen appears. 2 Press the CURSOR F or G button to select a setting. 3 Press the ENTER button to enter the setting. • The "Speaker Setup" menu appears. 4 Press the CURSOR D or H button to select "Exit", then press the ENTER button. • The "System Setup" menu reappears. 1 Press the STANDARD button to select the STANDARD (DOLBY/DTS SURROUND) modes. • This screen is not displayed when not using a subwoofer and all speakers are set to small size. 2 Press the TEST TONE button. • Test tones are output from the different speakers. 3 Press the CURSOR F or G button to adjust so that the volume of the test tones is the same for all the speakers. 4 After completing the adjustment, press the TEST TONE button again. 50 ENGLISH