Denon AVR-4806CI Owners Manual - Page 82

Advanced Operation 3. Tuner system buttons IR segment MODE SELECTOR NUMBER RC SETUP •, ª BAND MODE MEM SRCH SFT CH +, - A ~ G 1 ~ 8 : Tuning up/down : Switch between AM, FM and XM bands : Switch between AUTO and MANUAL : Preset memory : RDS search : Switch preset channel range : Preset channel up/down : Preset channel range : Preset channel Preset memory • The included remote control unit (RC-1036) can be used to operate devices of different brands by registering the preset number corresponding to the brand of your device. • For some models the remote control unit or the device may not operate properly. In this case, use the learning function ( page 85, 86) to store your device's remote control signals in the included remote control unit. 1 Press the MODE SELECTOR button for the component you want to preset. Presetting is not possible for the AMP, ZONE2, ZONE3, ZONE4, TUNER and SYSTEM CALL modes. 2 Press and hold the RC SETUP button for at least three seconds. • The top IR segment blinks twice. 3 Referring to the included List of Preset Codes ( End of this manual), press the NUMBER button to input the preset code (a 5-digit number) for the manufacturer of the component whose signals you want to store in the memory. • The top IR segment blinks once after each button press. • If the remote recognizes the manufacturer's code, the IR segment blinks twice. You have 10 seconds to press each digit. If it takes longer than that, the remote "times out" and you must begin again. 82