Denon DCM-460 Operating Instructions - Page 9

(3) Connecting the Digital Output Jack (COAXIAL) Use a 75 Q /ohm pin cord to connect the digital output jack (COAXIAL) of the DCM-560/460 to the digital input jack (COAXIAL) on a digital processor or D/A unit, available in stores. DCM-560 / 460 I Connection Precautions • Before proceeding with connections or disconnections of cables and power cords, be sure to turn all system components off.. • Ensure that all cables are connected properly to the L (left) and . Fi (right) jacks. • Insert plugs fully into the terminals. • Connect the output jacks to the amplifier CD, AUX or TAPE PLAY input jacks. (Amplifier) Power supply outlet Digital processor or D/A unit OPENING AND CLOSING THE DRAWER AND LOADING A DISC Opening and closing the drawer (This operation only works while the power is on.) 1. Press the power switch (POWER) to turn on the power. 2. Press the open/close button ( .4. OPEN/CLOSE). How to load a disc • Make sure the drawer is completely open. • Hold the disc by the edges and place it on the disc tray. (Do not touch the signal surface, i.e., the glossy side.) • Set the disc properly in the tray according to its size. Set 8cm discs in the center hole. Set 12cm discs in the outer hole. • When the drawer is opened during the stop mode, discs can be loaded in the disci to disc 4 trays. If the DISC SKIP button is pressed, the carousel turns and a disc can be loaded in the disc 5 tray. When the drawer is opened during the play mode, it is possible to load and unload discs in all of the disc trays other than the one whose disc is currently playing. In this case, the DISC SKIP button will not operate. • Press the open/close button (A OPEN/CLOSE) to close the drawer. LABEL SIDE UP. WARD S qs) OWN Caution: • The player will not operate properly and the disc may even be damaged if it is not set correctly. S 0 • If your finger should get caught in the drawer when it closes, press the open/close button ( A OPEN/CLOSE). • Do not place any foreign objects on the disc tray, and do not place more than one disc on the tray at a time. Otherwise malfunction may occur. • Do not push in.the disc tray manually when the power is off as this may cause malfunction and damage the CD player. • Do not touch the carousel while it is turning. Also, do not turn the carousel by hand when it is stopped. Doing so could damage it. • Do not insert disc where indicated by arrow. This could damage the internal mechanism in the unit. c=, 9