Denon DCM-5001 Serial Protocol - Page 13
Request System Status
View all Denon DCM-5001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
.3 Request System Status This requests a system status, along with the disc number being transferred or the one installed in the drive. bytebit 7 6 5 4 3 2 1 0 0 STX 02h 1 Command code 0 2 ETX 03h 3 BCCH high-level 4 BCCL low-level Answers returned bytebit 7 6 5 4 3 2 1 0 0 STX 02h 1 Reply code 0 2 Answer code 3 System status code 4 Zone mode ( single zone1dual zone2 ) 5 Zone 1 status 6 Zone 2 status 7 Disc number in zone 1 (100 digits) 8 Disc number in zone 1 (10 digits) 9 Disc number in zone 1 (1 digit) 10 Disc number in zone 2 (100 digits) 11 Disc number in zone 2 (10 digits) 12 Disc number in zone 2 (1 digit) 13 Track number of zone 1 (10 digits) 14 Track number of zone 1 (1 digit) 15 Track number of zone 2 (10 digits) 16 Track number of zone 2 (1 digit) 17 Elapsed time of zone 1 (minutes, 10 digits) 18 Elapsed time of zone 1 (minutes, 1 digit) 19 Elapsed time of zone 1 (second, 10 digits) 20 Elapsed time of zone 1 (second, 1 digit) 21 Elapsed time of zone 1 (frame, 10 digits) 22 Elapsed time of zone 1 (frame, 1 digit) 23 Elapsed time of zone 2 (minutes, 10 digits) 24 Elapsed time of zone 2 (minutes, 1 digit) 25 Elapsed time of zone 2 (second, 10 digits) 26 Elapsed time of zone 2 (second, 1 digit) 27 Elapsed time of zone 2 (frame, 10 digits) 28 Elapsed time of zone 2 (frame, 1 digit) 29 ETX 03h 30 BCCH high-level 31 BCCL low-level Special conditions · If the status parameters of zones 1 and 2 of a specific answer are J ( the CD-TEXT disc is loaded ), the unit shall issue the Request CD-TEXT Name command and acquire new name information. · While this unit runs in the single zone mode, the status of the currently active disc is parametrized as zone 1 status, and the status of the disc on standby as zone 2 status. · If there is no disc on the driver "Disc NO. Parameter" is " 0". · Track NO. Parameters are '0' when there is no disc on the driver ,or the case of not finishing to read the TOC , or at the Stop mode. · A -time parameters are "0" except for play mode, pause mode,or during scanning. · At the standby condition, the unit accepts Request System Status, Power On, Request CPU Version, and Request Error Status commands. In the case of other commands , it returns command format error "1" as the Answer code. · TOC Read OK and Load CD-TEXT Disc zone statuses proceed to the next statuses after sending the Request System Status command. · During cross-fading, the fade-in status is set in the Zone 1 fields and the fade-out status is set in the Zone 2 fields. The fade-out zone status (Zone 2) is 4DH ("M"). The Disk No, Track No, and Time Elapsed fields are all zeros. Other