Denon DCM-5001 Serial Protocol - Page 19
Disc Skip
View all Denon DCM-5001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
.9 Disc Skip This selects a disc in a selected zone. If the unit receives this command while in playback or a pause, the unit completes disc selection and becomes ready to play back, then continues to run according to its immediately previous state the unit plays only 1 track. bytebit 7 6 5 4 3 2 1 0 0 STX 02h 1 Command code T 2 Skip code Forward Reverse Direct D 3 Disc number ( 100 digits ) 4 Disc number ( 10 digits ) 5 Disc number ( 1 digit ) 6 ETX 03h 7 BCCH high-level 8 BCCL low-level Answers returned bytebit 7 6 5 4 3 2 1 0 0 STX 02h 1 Reply code T 2 Answer code 3 ETX 03h 4 BCCH high-level 5 BCCL low-level Special conditions · Disc number parameters ( Byte 3-5 ) are effective only when the skip code is D . · It is canceled the disc or the track specified under PLAY command. It should send the command after this command to reserve the next disc or the track. · This command is valid only when the zone status is Play (F) or PAUSE (G). · The unit can skip to a maximum disc with Forward (+) and to a minimum disc with Reverse (- ) and when it goes to more than those discs, the Order Disc None (3) answer code is issued. · This command is ignored when a disc specified by a skip code "+" or "-" of this command is used in the other zone in the multi-zone mode. Other