Dewalt DW08802CG Instruction Manual - Page 11
Maintenance, Troubleshooting
View all Dewalt DW08802CG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Using the Pivot Bracket • Calibration checks and other maintenance repairs may be The laser has a magnetic pivot bracket (Figure B ) permanently performed by DEWALT service centers. E attached to the unit. WARNING: Troubleshooting Position the laser and/or wall mount on a stable surface. Serious personal injury or damage to the The Laser Does Not Turn On laser may result if the laser falls. • Check the AA batteries to make sure: • The bracket has magnets (Figure B 2 ) which allow the unit to be mounted to most upright surfaces made of steel or iron. • Each battery is installed correctly, according to (+) and (-) listed inside the battery compartment. Common examples of suitable surfaces include steel framing • The battery contacts are clean and free of rust or corrosion. studs, steel door frames, and structural steel beams. • The batteries are new, high-quality, name brand batteries • The bracket has a keyhole slot (Figure B 1 ) so it can be to reduce the chance of battery leakage. hung from a nail or screw on any kind of surface. • Make sure the AA batteries are in proper working condition. If Using the Laser with Accessories in doubt, try installing new batteries. WARNING: Since accessories other than those offered by • When using rechargeable batteries, make sure the batteries are fully charged. DEWALT have not been tested with this laser, use of • Be sure to keep the laser dry. such accessories with this laser could be hazardous. • If the laser unit is heated above 120 ˚F (50 ˚C), the unit will Only use DEWALT® accessories that are recommended for use not turn ON. If the laser has been stored in extremely hot with this model. Accessories that may be suitable for one laser temperatures, allow it to cool. The laser level will not be may create a risk of injury when used with another laser. damaged by using the Power/Transport Lock switch before cooling to its proper operating temperature. The bottom of the laser is equipped with a 1/4-20 female thread (Figure B 3 ) to accommodate current or future DEWALT® accessories. Only use DEWALT® accessories specified for use The Laser Beams Flash with this laser. Follow the directions included with the accessory. When in self-leveling mode, the laser is designed to self-level Recommended accessories for use with this laser are available at extra cost from your local dealer or authorized service center. If you need assistance locating any accessory, please contact your nearest DEWALT service center or visit our website: http:// up to an average of 4° in all directions. If the laser is tilted so much that the internal mechanism cannot level itself, the laser beams will flash indicating that the tilt range has been exceeded. www.DEWALT.com. THE FLASHING BEAMS CREATED BY THE LASER ARE NOT LEVEL OR PLUMB AND SHOULD NOT BE USED FOR DETERMINING OR MARKING LEVEL OR PLUMB. Try Maintenance repositioning the laser on a more level surface. • When the laser is not in use, clean the exterior parts with a damp cloth, wipe the laser with a soft dry cloth to make sure it is dry, and then store the laser in the kit box provided. • Although the laser exterior is solvent resistant, NEVER use solvents to clean the laser. • Do not store the laser at temperatures below -5 ˚F (-20 ˚C) or above 140 ˚F (60 ˚C). The Laser Beams Will Not Stop Moving The laser is a precision instrument. Therefore, if it is not positioned on a stable (and motionless) surface, the laser will continue to try to find level. If the beams will not stop moving, try placing the laser on a more stable surface. Also, try to make sure that the surface is relatively flat and level, so that the laser is stable. • To maintain the accuracy of your work, check the laser often to make sure it is properly calibrated. 11