Electrolux E42BS75ETT Owners Manual - Page 32

Installation Instructions [] SECURE REFRIGERATOR TO CABINETS Whenever possible, perform this step for anti-tip security. The refrigerator must be secured to prevent tipping. • Raise the grille panel to access case trim. • Drive a screw through the trim and into the adjacent cabinet using holes provided. • Follow the same procedure on the opposite side. Drive Screws Through CaseTrim Int0 Adjacent Cabinets [] ADJUST DOOR SWING NOTE: This refrigerator has a 2-position door stop. When space does not allow the door to swing open fully to 130 °, you may change the door swing to a 90 ° opening. SKIP THIS STEP IF DOOR OPENING IS SATISFACTORY FOR YOUR INSTALLATION SITUATION. • Open the door to view the bottom hinge. Note the door stop pin location. The pin is factory installed in the 130 ° position. • Partially close the door. From above, use a flat-head screwdriver to unscrew the door stop pin and reinstall into the 90 ° position. /,,/ J/l! I/if !/f/ Interior Hinge ///, I_ /y °°r d _J INSTALL GRILLE PANEL • Raise the grille panel to the stop position, I ° ° _Raise t _Grille_ _Panel _ [] 4g. == Remove 4 screws on bottom trim; retain all screws. Remove bottom trim. NOTE: Stainless steel and acrylic panels are covered with a protective film. Remove the film before installing the panel. Slide panel over the metal backer panel and under the trim. • If necessary, tap with a wood block until panel slips under the top trim piece. • Reassemble bottom trim. Tighten screws. 32