Electrolux E42BS75ETT Owners Manual - Page 35
Powerswtch
View all Electrolux E42BS75ETT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Installation Instructions 1_ CONNECT WATER SUPPLY Check to make sure that Master Power switch is in the O (OFF) position. TURN ON THE POWER • Set the Master Power switch to the I (ON) position, • Check to make sure power to refrigerator is on by opening refrigerator door to see if interior lights are on. _wR_ Water Supply • Locate and bring tubing to the front of the cabinet. • Turn the water on to flush debris from line. Run about a quart of water through tubing into a bucket, then shut off water. Copper Tubin 9 • Slip a 114" nut and ferrule onto end of copper tubing. Insert tube into the union fitting on the unit and tighten nut to union, • Turn on the water to check for leaks. Note: Make sure excess tubing length does not interfere with toekick installation. Master Powerswtch / • The temperature controls are preset at 37 ° for the Fresh Food section and 0 ° for the Freezer section. • Allow 24 hours to stabilize before making adjustments. • Dispense water for 2 minutes to remove trapped air from the water system. 35