Electrolux ERFG2393AS Complete Owners Guide - Page 15

15 DOOR HANDLE INSTALLATION CAUTION Wear gloves and safety goggles. Use extreme CAUTION when installing these handles. Door Handle Mounting Instructions 1. Remove the handles from the carton and any other protective packaging. 2. Position the refrigerator handle end over the upper and lower preinstalled shoulder bolts (A) that are fastened into door, ensuring the holes for the set screws are facing toward the opposite door. 3. While holding the handle firmly against door, fasten the furthest upper and the furthest lower Allen set screws (B) with the supplied Allen wrench. 4. Repeat steps 2 and 3 to install the opposite handle. Ensure the holes for the set screws are facing toward the first door. 5. Firmly tighten the inside Allen set screws. 6. Position the freezer handle end over the left and right preinstalled handle shoulder bolts (A) that are fastened to the door, ensuring the holes for the set screws are facing down. 7. While holding the handle firmly against door, loosely tighten the far right Allen set screw (B) with the supplied Allen wrench until there is no gap between handle and the door. 8. Still holding the handle firmly to the door, firmly tighten the far left Allen set screw (B) with supplied Allen wrench. 9. Return to the far right Allen set screw (B) and firmly tighten it with the supplied Allen wrench. 10. Firmly tighten the inside Allen set screws. Mounting the Refrigerator Handles A x2 B A x2 B B x2 A x2 B A Mounting the Freezer Handle A A B x2 x2 B  NOTE When tightening the Allen set screws, it is important to apply force to the longer arm of the Allen wrench supplied in the handle packaging.  NOTE Tighten all set screws so the screws are below the surface of the handle. Draw the handles tight to the freezer and refrigerator doors with no gaps. Opening the opposite door while tightening the Allen screw makes installation easier. The door handle may loosen over time or if you do not install it properly. If this happens, tighten the set screws on the handles.