Electrolux ERFG2393AS Complete Owners Guide - Page 37
Concern, Potential Cause, Common Solution, Automatic Ice Maker Cont'd
View all Electrolux ERFG2393AS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
37 TROUBLESHOOTING Concern Potential Cause Automatic Ice Maker (Cont'd) Common Solution Ice maker is not making enough ice. • Ice maker is producing less ice than you expect. • The ice maker will produce approximately 2 to 2.5 lbs every 24 hours depending on usage conditions. • The water filter may be clogged with foreign material. • If water dispenses slower than normal, or if the filter is 6 months old or older, you should replace it. • The water supply line is kinked. • Ensure that the supply line does not kink when the refrigerator is pushed into place against the wall. • Saddle valve on cold water pipe is clogged or restricted by foreign material. • Turn off the household water line valve. Remove the valve. Clean the valve. Replace valve if necessary. • Heavy traffic, opening or closing of the doors excessively. • Press Freeze Boost to temporarily increase ice production rate. • Control is set too warm. • Set the appliance display control to colder setting to improve performance of the ice maker. Allow 24 hours for temperature to stabilize. • Water pressure is • Have someone turn up the cut-off and extremely low. Cut-off and cut-on pressure on the water pump cut-on pressures are too system (well systems only). low (well systems only). • Reverse osmosis system is • It is normal for a reverse osmosis in regenerative phase. system to be below 20 psi during the regenerative phase. Ice maker • Ice maker bail arm is being • Move any item or frozen ice cubes will not stop held down by a package that may block the bail arm from making ice. in the freezer that has fallen being in the off or upward position. against ice maker. See ICE MAKER. Ice cubes are freezing together. • Ice cubes are not being • Remove the ice bin and discard the used frequently enough or ice. The ice maker will produce a fresh interruption of power for supply. Use the Ice at least twice prolonged time. weekly to keep the cubes separated. • Ice cubes are hollow • This generally occurs when the ice (shells of ice with water maker does not get enough water. inside). The hollow cubes This is usually the result of a clogged break open in the bin water filter or restricted water supply. and leak their water onto Replace the water filter and if the existing ice, which causes condition still occurs check for a it to freeze together. clogged saddle Valve, the water valve not turned on all the way or a kinked water supply line.