Electrolux ERFG2393AS Complete Owners Guide - Page 39

Concern, Potential Cause, Common Solution, Opening/Closing Of Doors/Drawers, Running of Refrigerator

Page 39 highlights

39 TROUBLESHOOTING Concern Potential Cause Common Solution Opening/Closing Of Doors/Drawers Door(s) will not close. • Door was closed too hard, causing other door to open slightly. • Close both doors gently. • Refrigerator is not level. • Ensure the floor is level and solid, It rocks on the floor when and can adequately support the moved slightly. refrigerator. Contact a carpenter to correct a sagging or sloping floor. • Refrigerator is touching a wall or cabinet. • Ensure the floor is level and solid, and can adequately support the refrigerator. Contact a carpenter to correct a sagging or sloping floor. Drawers are • Food is touching shelf on difficult to top of drawer. move. • Track that drawers slide on is dirty. • Remove the top layer of items in the drawer. • Ensure you properly install the drawer on the track. • Clean the drawer, rollers, and track. See CARE AND CLEANING. Running of Refrigerator Compressor • Freezer control is set to off. • Set freezer control. does not run. • Refrigerator is in defrost cycle. • This is normal for a fully automatic defrost refrigerator. The defrost cycle occurs periodically, lasting about 30 minutes. • Plug at electrical outlet is disconnected. • Ensure the plug is tightly pushed into the outlet. • House fuse blown or tripped circuit breaker. • Check/replace fuse with a 15-amp timedelay fuse. Reset the circuit breaker. • Power outage. • Check the house lights. Call the local electric company. Refrigerator • seems to run too much or too long. Your variable speed compressor is designed to run 100% of the time except during the defrost cycle. At times it will run faster, such as after a defrost cycle. • It is normal for the compressor to run continuously except during the defrost mode. Digital Temperature Setting Display Digital • Electronic control temperature system has detected a displays an performance problem. error. • Call your Electrolux service representative who can interpret any messages or number codes flashing on the appliance control display.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42

39
Concern
Potential Cause
Common Solution
Opening/Closing Of Doors/Drawers
Door(s) will
not close.
Door was closed too
hard, causing other door
to open slightly.
Refrigerator is not level.
It rocks on the floor when
moved slightly.
Refrigerator is touching a
wall or cabinet.
Close both doors gently.
Ensure the floor is level and solid,
and can adequately support the
refrigerator. Contact a carpenter to
correct a sagging or sloping floor.
Ensure the floor is level and solid,
and can adequately support the
refrigerator. Contact a carpenter to
correct a sagging or sloping floor.
Drawers are
difficult to
move.
Food is touching shelf on
top of drawer.
Track that drawers slide
on is dirty.
Remove the top layer of items in
the drawer.
Ensure you properly install the drawer
on the track.
Clean the drawer, rollers, and track.
See
CARE AND CLEANING
.
Running of Refrigerator
Compressor
does not
run.
Freezer control is set to
off
.
Refrigerator is in
defrost cycle.
Plug at electrical outlet
is disconnected.
House fuse blown or
tripped circuit breaker.
Power outage.
Set freezer control.
This is normal for a fully automatic
defrost refrigerator. The defrost cycle
occurs periodically, lasting about
30 minutes.
Ensure the plug is tightly pushed into
the outlet.
Check/replace fuse with a 15-amp time-
delay fuse. Reset the circuit breaker.
Check the house lights. Call the local
electric company.
Refrigerator
seems to run
too much or
too long.
Your variable speed
compressor is designed
to run 100% of the time
except during the defrost
cycle. At times it will run
faster, such as after a
defrost cycle.
It is normal for the compressor to
run continuously except during the
defrost mode.
Digital Temperature Setting Display
Digital
temperature
displays an
error.
Electronic control
system has detected a
performance problem.
Call your Electrolux service
representative who can interpret any
messages or number codes flashing
on the appliance control display.
TROUBLESHOOTING