Electrolux EW30DS80RS Complete Owner s Guide English - Page 10
Installing Burner Grates
View all Electrolux EW30DS80RS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 Before Setting Surface Controls For the 18 000 BTU burner: Place the burner head over the gas orifice (Figure 8). Be careful not to damage the electrode while placing the burner head over the orifice. Make sure electrode fits correctly into slot in burner head. IMPORTANT! For proper ignition, the burner ring alignment tab must align with burner base alignment tab slot. INSTALLING BURNER GRATES Surface burners may appear to have cooled after they have been turned off. The surface burner may still be hot and burns may occur if the surface burner is touched before it has cooled sufficiently. Burner Ring Alignment Tab Burner Alignment Tab Slot Figure 8: Setting G5 burner correctly Burner Cap Burner Ring Burner Base Simmer Head Figure 10: Burner grates placement Make sure the burner grates are properly placed on the cooktop before using the surface burners. The grates are designed to rest inside the recess on the cooktop. To install burner grates, place grates flat-side down and align into the cooktop recess. Grates should rest flush against each other and against the sides of the recess (Figure 10). Figure 9: 18 000 BTU burner cap and head When the burner ring is properly seated, it will click into place. When the burner cap is properly set in place, it should not move out of the recessed area of the burner head.