Electrolux EW30DS80RS Complete Owner s Guide English - Page 46
Setting Self Clean
View all Electrolux EW30DS80RS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
46 Setting Oven Controls Setting Self Clean Do not leave small children unattended near the appliance. During the self clean cycle, the outside of the oven can become very hot to touch and can cause burns. Do not force the oven door open when self clean is active. This can damage the automatic door-locking system. Use caution when opening the door after self cleaning. The oven may still be very hot and can cause burns. To avoid possible burns, stand to one side of the oven when opening the oven door to allow hot air or steam to escape. The self clean feature will not operate if the lower or upper oven is on. IMPORTANT! The kitchen area should be well ventilated. Use an open window, ventilation fan, or exhaust hood during the first self clean cycle to help eliminate the normal odors associated the initial clean cycle. To start a self clean: 1. Ensure the oven is empty and remove all oven racks. Be sure the clock is set with the correct time of day and the oven door is completely closed. 2. Press UPPER OVEN to light up the available cooking modes keys. 3. Press clean. 4. The self clean feature allows you to choose one of three time options. Press lite for a 2-hour clean (Figure 46); or 7. Press START enter to begin cleaning. Once active, the door lock motor will begin locking the oven door. DOOR will blink in the display. • Do not try to open the door when the DOOR message is blinking or once it is on (allow about 15 seconds for the oven door to completely lock). • Once the oven door is locked the CLn message will appear in the display for the entire self clean cycle. When the self clean cycle is finished: Use caution when opening the oven door after self cleaning. The oven may still be very hot and can cause burns. To avoid possible burns, stand to the side of the oven when opening the oven door to allow hot air or steam to escape. The oven bake and broil elements may appear to have cooled after they have been turned off. The elements may still be hot, and burns may occur if these elements are touched before they have cooled. 1. The time of day and Hot will show in the display (Figure 49). 2. Once the oven has cooled (about 1 hour) and Hot is no lon- ger displayed, the door lock message will flash. When this message stops flashing in the display, the door has finished unlocking and may be opened. Figure 49: Hot oven (door still locked) Figure 46: 2 hour lite clean 5. Press med (normal) for a 3-hour clean (Figure 47); or Figure 47: 3 Hour normal clean 6. Press heavy for a 4-hour clean (Figure 48). The oven bake and broil elements may appear to have cooled after they have been turned off. The elements may still be hot and burns may occur if these elements are touched before they have cooled. 3. After the oven has cooled, wipe away any residue or powdered ash from the oven interior using a damp cloth or paper towel. A self clean cycle will not start if the control lock feature is active. If a self clean cycle was started but did not finish due to a power outage, your oven may not have completely cleaned. Figure 48: 4 Hour heavy clean