Electrolux EW30DS80RS Complete Owner s Guide English - Page 52

52 Care and Cleaning REMOVING AND REPLACING THE OVEN DOOR To remove the oven door: To avoid possible injury when removing or replacing the oven door, follow the instructions below carefully and always hold the oven door with both hands positioned away from the door hinge area. Oven door hinge locations The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down. To prevent possible burns, do not attempt to remove the oven door until the oven has completely cooled. 1. Open oven door completely, horizontal with floor (Figure 55). 2. Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (Figure 56). A tool such as a small flat-blade screwdriver may be required. 3. Firmly grasp both sides of oven door along the door sides. Do not use the oven door handle (Figure 57). 4. Close the door until it is about ten percent open. The oven door may stop into this position just before fully closing. 5. With the oven door in the stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (Figure 58). To Replace Oven Door: 1. Firmly grasp both sides of oven door along the door sides. Do not use the oven door handle (Figure 57). 2. Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (Figure 58). The hook of the hinge arms must be fully seated onto the roller pins. 3. Fully open the oven door, horizontal with floor (Figure 55). 4. Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges to the locked position; then, close the oven door (Figure 56). Figure 55: Door hing location LOCK Figure 56: Door hinge locks oven door about 10° hinge IMPORTANT! Special Door Care Instructions - Most oven doors contain glass that can break. Do not close the oven door until all the oven racks are fully in place. Do not hit the glass with pots, pans, or any other object. Scratching, hitting, jarring, or stressing the glass may weaken its structure causing an increased risk of breakage at a later time. Figure 57: Holding door for removal roller pin hinge arm Figure 58: Location of hinge arm and roller pin