Electrolux EW30DS80RS Complete Owner s Guide English - Page 47
Setting Delayed Self Clean
View all Electrolux EW30DS80RS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Setting Oven Controls 47 To cancel self clean: 1. Press CANCEL off. Use caution when opening the oven door after self cleaning. The oven may still be very hot and can cause burns. To avoid possible burns, stand to the side of the oven when opening the oven door to allow hot air or steam to escape. The oven bake and broil elements may appear to have cooled after they have been turned off. The elements may still be hot, and burns may occur if these elements are touched before they have cooled. 2. If the self clean cycle has heated the oven to a high enough temperature, Hot will appear in the display (Figure 50). Allow enough time for the oven to cool and the door to unlock before the oven door may be opened. Figure 50: Oven too hot for door to unlock IMPORTANT! Before restarting self clean, read the following important notes: • If your clock is set with the (default) 12 hr display mode, the delay start for a self clean can only be programmed to start up to 11 hours and 59 minutes after the time showing in the display (be sure to set the clock to current time before programming a delay start). To set a delay start self clean to begin 12 or more hours (maximum is 23 hours and 59 minutes) after the time of setting, be sure to first set the control in the 24 Hr display mode. • If self clean was active and then interrupted by a power failure or cancelled before the oven was thoroughly cleaned, it may be necessary to run another self clean cycle. Setting Delayed Self Clean You may want to set the oven to perform a self clean at a later time (up to 12 hours later). The end time key will determine when the cleaning will stop. The end time must be set far enough from the real time to allow for the type of clean cycle you select, whether 2, 3, or 4 hours. Remember to add 30 to 40 additional minutes of cooling time before using the oven for cooking. Setting for a heavy (4 hour) self clean cycle to end at 8:00 o'clock: Do not leave small children unattended near the appliance. During the self clean cycle, the outside of the oven can become very hot to touch and can cause burns. Do not force the oven door open when self clean is active. This can damage the automatic door-locking system. Use caution when opening the door after self cleaning. The oven may still be very hot and can cause burns. To avoid possible burns, stand to one side of the oven when opening the oven door to allow hot air or steam to escape. IMPORTANT! The kitchen area should be well ventilated. Use an open window, ventilation fan, or exhaust hood during the first self clean cycle to help eliminate the normal odors associated the initial clean cycle. 1. Ensure the oven is empty and remove all oven racks and racks support. Be sure the clock is set with the correct time of day and the oven door is completely closed. In this example, the time of day should be earlier than 4:00 o'clock. 2. Press UPPER OVEN to light up the available cooking modes keys. 3. Press clean. 4. Press heavy. 5. Press cook options. The end time icon will appear. 6. Press end time. The numeric keypad will illuminate. 7. Enter 8 0 0 on the numeric keypad. 8. Press START enter. The display will indicate the time remaining before self clean begins. When the self clean cycle begins, the display will show the time remaining in the self clean cycle. 8 0 0 If you want to set a delayed self clean to end between 12 and 24 hours, use the user pref key to set the 12hr energy saving mode (ES) to Off and also set the clock (CLO) to the 24 hr mode.