Epson 7850p Product Information Guide - Page 15

EPSON PowerLite 7850p Projector 3. Click the Configure button. Then click the Advanced tab on the screen that appears. You see a screen like this: 4. Ad Hoc mode: Highlight Network Type in the Property list and set the Value to 802.11 Ad Hoc. Access Point mode: Highlight Network Type and set the Value to Infrastructure. 5. Ad Hoc mode: Highlight SSID and set the Value to match the name you gave the projector's ESSID (for example, CONF ROOM). If your network card uses channel mode instead, set the correct channel, 1 to 11, to match that of the projector. Access Point mode: Highlight SSID and set the Value to match the name assigned to the access point. 6. Highlight Encryption and make sure it is disabled. 7. Click the General tab and make sure the network card or wireless network device is enabled. 8. Ad Hoc mode: Click OK to close the network card's properties dialog box. Then go to "Projecting Wirelessly" on page 15. Access Point mode: On the General tab, select Internet Protocol, then click the Properties button. You see this screen: 9. If your access point uses DHCP, select Obtain IP address automatically. Otherwise, select Use the following IP address and enter the required information. ❏ IP address: Type in the IP address you want to assign to the computer. It must be formatted like other addresses on the network; usually the first three segments (XXX.XXX.XXX) match the access point's IP address. ❏ Subnet mask: For example, 255.255.255.000, but this too must match how your network was set up. ❏ Default gateway: Enter the IP address that was assigned to the access point when it was set up. 10. When done, click OK. 11. Click the Wireless Networks tab. You see this screen: 14 - EPSON PowerLite 7850p Projector Note: If you don't see this tab, you may need to enable your wireless card or network device by clicking Configure to access the device settings; then follow any instructions on the screen to enable the device. 6/03