Epson 7850p Product Information Guide - Page 19
Setting Up the Projector on a Wired Network, Opening and Closing EMP Monitor, To start EMP Monitor
UPC - 010343845992
View all Epson 7850p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
EPSON PowerLite 7850p Projector If you're using a network management utility running SNMP, you can configure your network to send trap alerts even without a plug-n. See the User's Guide for more information. Make sure you have installed the EMP Monitor software (included on the projector's CD-ROM) on the computer you want to use to monitor your projectors. (See the User's Guide for instructions.) Note: Your computer must be running Microsoft Windows XP, 2000, Me or 98. Setting Up the Projector on a Wired Network This section explains how to configure projectors on a wired network. You can also configure projectors for wireless communication. See "Configuring the Connection" on page 12 for details. 1. Insert the PCMCIA LAN card into the card slot on the back of the projector. Then connect the projector to your network using a commercially available 100baseTX or 10baseT network cable. 2. Turn on the projector. 3. Press the Menu button on the remote control and select Network from the Advanced2 menu. Video Audio Effect Setting User's Logo Advanced1 Advanced2 About Reset All Brightness Control : High Low Projector ID : 1 Set Network Set COM Port : RS-232C USB Auto setup : ON OFF BNC Sync Termination : ON OFF Reset Execute Select Network [ ]: Select [ ]: Enter [Menu]: Exit 4. If your network assigns addresses automatically, turn on DHCP. If your network does not assign addresses automatically, turn off DHCP and enter the projector's IP Address, Subnet Mask, Gateway Address, and MAC Address, as needed. ❏ To enter numbers using the remote control, press the Num button until it lights, then use the numeric keypad. ❏ To change the network addresses from the projector's control panel, press the right and left arrow buttons to select the part of the address you want to enter, then use the up and down arrow buttons to increase or decrease the numeric value. Increase or decrease the value Select the part of the address to change 5. When you finish changing an address in the network menu, press the Enter button (on the remote control) or the Auto/Enter button (on the projector). This stores the value. 6. When you're done making all necessary changes, press ESC to exit the menu system. Opening and Closing EMP Monitor To start EMP Monitor, click Start > Programs or All Programs > EPSON Projector > EMP Monitor. If you've added the program to the Startup programs folder, it may already be open. If so, click the icon in the system tray on the lower-right corner of your screen to display the EMP Monitor window: Click here to start EMP Monitor To close EMP Monitor, right-click the program icon shown above, then select Exit. Num button Zero 18 - EPSON PowerLite 7850p Projector 6/03