Epson 830p User Manual - Page 74
Changing the Remote Control ID, Repeat steps 1 and 2 each time you want to switch projectors.
UPC - 010343851177
View all Epson 830p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Changing the Remote Control ID To change the remote control's ID to match the projector's ID, follow these steps: 1. Press the ID button on the remote control. You see it light. 2. Press one of the numbered buttons on the remote control to select the ID of the projector you want to operate. The ID button's light shuts off and the new ID is registered. 3. Repeat steps 1 and 2 each time you want to switch projectors. To check the remote control's current ID, do the following: 1. Press the ID button twice. After a moment, the button flashes. 2. Count the number of flashes; this number corresponds to the remote control's ID. (If it doesn't flash, the ID is set to zero.) 74 Fine-Tuning the Projector
74
Fine-Tuning the Projector
Changing the Remote Control ID
To change the remote control’s ID to match the projector’s ID, follow
these steps:
1.
Press the
ID
button on the remote control. You see it light.
2.
Press one of the numbered buttons on the remote control to select
the ID of the projector you want to operate.
The
ID
button’s light shuts off and the new ID is registered.
3.
Repeat steps 1 and 2 each time you want to switch projectors.
To check the remote control’s current ID, do the following:
1.
Press the
ID
button twice. After a moment, the button flashes.
2.
Count the number of flashes; this number corresponds to the
remote control’s ID. (If it doesn’t flash, the ID is set to zero.)