Epson PowerLite 1725 Operation Guide - EasyMP - Page 88
Error Messages, Remedy, ERR Number, Error Meaning, Check, Sudden changes to the EasyMP screen
View all Epson PowerLite 1725 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Troubleshooting 88 fEMP NS Connection cannot be used to make a connection Check the message at the bottom-left of the screen and then apply the following countermeasures. Error Messages Remedy The application version used is not supported. You are using an old version of EMP NS Connection. A connection cannot be made. Install the current version from the "EPSON Projector Software for Meeting & Presentation CD-ROM" supplied with the projector. fSudden changes to the EasyMP screen ERR at the bottom left of the screen: Check the numbers and make the following remedies. ERR Number Error Meaning Remedy 2,50,53,245,-103 Failed to startup EasyMP. Turn the power for the projector off and then back on again. 51,52,100 Failed to process EasyMP. If you're using EMP NS Connection, restart EMP NS Connection. If you're projecting via USB, reconnect the USB cable. -101 Communication was cut off from the access point. Check the access point operation. -102,-105 Wireless communication is unstable. Network traffic may be high. Wait a while, then try reconnecting. fWhen a connection is made using EMP NS Connection, the projected image remains as is, and a connection cannot be made from another computer. Check Remedy Did the presenter leave the conference room without cutting off the network connection? With EMP NS Connection, the connection with the computer that was previously connected can be cut off when another computer tries to connect with the projector, and it connects with the computer that is trying to connect. Therefore, when a projector keyword is not set for the projector, or if you know the projector keyword, you can cut off the current connection and, if you perform a connection operation, you can connect to the projector. When a projector keyword is set for the projector, if you do not know the projector keyword, cut off projection from the projector and reconnect. To cut off connection from the projector, press the [Esc] button on the remote control, select "Close" from the close menu and press the [Enter] button on the remote control. When it cuts off, you can connect from the target computer.