Epson S6 User Manual - Page 60

Problems when projection starts, Check, Remedy

Get Epson S6 PDF manuals and user guides View all Epson S6 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 60 highlights

Problem Solving 60 f Problems when projection starts f Power does not turn on Check Did you press the [t] button? Are the indicators switched off? Do the indicators turn on and off when the power cable is touched? Is the control panel lock set to "Full Lock"? Was the power cable plugged back in immediately after Direct Power Off, or is the breaker turned off? Remedy Press the [t] button to turn the power on. The power cable is not connected correctly or power is not being supplied normally. Connect the projector's power cable correctly. Check that your electrical outlet or power source is functioning correctly. There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If this does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide. s Epson Projector Contact List When you press and hold down the [Enter] button on the control panel for about seven seconds, a message is displayed and the lock is released. s p.34 When the operation to the left is performed when "Direct Power On" is set to "On", the power may not turn back on. Press the [t] button to turn the power back on.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
Problem Solving
60
f
Problems when projection starts
f
Power does not turn on
Check
Remedy
Did you press the [
t
] button?
Press the [
t
] button to turn the power on.
Are the indicators switched off?
The power cable is not connected correctly or power is not being supplied normally.
Connect the projector's power cable correctly.
Check that your electrical outlet or power source is functioning correctly.
Do the indicators turn on and off when the power cable is
touched?
There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power
cable. If this does not solve the problem, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the
Support and Service
Guide
.
s
Epson Projector Contact List
Is the control panel lock set to "Full Lock"?
When you press and hold down the [Enter] button on the control panel for about seven seconds, a message is
displayed and the lock is released.
s
p.34
Was the power cable plugged back in immediately after
Direct Power Off, or is the breaker turned off?
When the operation to the left is performed when "Direct Power On" is set to "On", the power may not turn
back on. Press the [
t
] button to turn the power back on.