Fisher and Paykel OR36SCG6R1 Installation Guide - Page 15

WARNING! Electrical Shock Hazard Plug into a grounded outlet. Do not remove ground prong. Do not use an adapter. Failure to follow these instructions can result in death, fire, or electrical shock. WARNING! VERY IMPORTANT Before any operation of maintenance disconnect the appliance from the electrical main supply. ELECTRICAL CONNECTION OR36 Dual Fuel models ONLY If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. Be sure that the electrical connection and wire size are adequate and in conformance with: O ANSI/NFPA 70 latest edition and local codes and ordinances. O CSA Standard C22.1, Canadian Electrical Code, Part 1 - latest edition, and all local codes and ordinances. ONLY FOR CANADA: A copy of the above code standards can be obtained from: CANADIAN STANDARDS ASSOCIATION 178 Rexdale Boulevard, TORONTO, ON M9W 1R3, CANADA z Do not ground to a gas pipe. z Check with a qualified electrical installer if you are not sure the range is properly grounded. z Do not have a fuse in the neutral or ground circuit. z When a 4-wire, two phase 240-208/120-volt, 60Hz, AC-only electrical supply is available, a 30 A maximum circuit protection is required, fused on both sides of the line. z A time-delay fuse or circuit breaker is recommended Recommended ground method z This range is equipped with a Certified Power Cord intended to be plugged into a standard 14-50R wall receptacle. Be sure the wall receptacle is within reach of range's final location. z Do not use an extension cord. z In the case of substitution of the power cord always replace it with a suitable UL or CSA approved one (with the same technical features of the replaced cord). z Tighten the power cord by using only the power cord strain relief bracket supplied with the appliance. z Allow enough slack to easily attach the cord terminals to the terminal block. z These operations must be carried out only by an authorized technician. Standard NEMA 14-50R wall receptacle IMPORTANT! The fourth (ground) prong should not, under ANY circumstances, be cut or removed. Power supply cord with NEMA 14-50P plug OR36 Gas Gas models ONLY If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. Check with a qualified electrician if you are not sure whether the range is properly grounded. Do Not ground to a gas pipe. z A 120-volt, 60-Hz, AC-only, 15 A, fused electrical supply is required. z A time-delay fuse or circuit breaker is recommended. z It is recommended that a separate circuit serving only this appliance be provided. z The outlet must be checked by a qualified electrician to see if it is wired with correct polarity. z This appliance, when installed, must be electrically grounded in accordance with local codes. Recommended ground method z For your personal safety, this range must be grounded. z This range is equipped with a 3-prong ground plug. z To minimize possible shock hazard, the cord must be plugged into a mating 3-prong ground-type outlet, grounded in accordance with the National Electrical Code ANSI/NFPA 70 latest edition and local codes and ordinances. z If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have a properly polarized and grounded, 3-prong outlet installed by a qualified electrician. IMPORTANT! The third (ground) prong should not, under ANY circumstances, be cut or removed. 3-prong ground plug Power supply cord 3-prong polarized ground-type outlet Ground prong 15