Fujitsu MAN3735MC Manual/User Guide - Page 81
Each mode setting (MP model only
![]() |
View all Fujitsu MAN3735MC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Table 5.1 SCSI ID setting (CN2 on MP model only) SCSI ID CN2 7-8 5-6 3-4 0 Open Open Open 1 Open Open Open 2 Open Open Short 3 Open Open Short 4 Open Short Open 5 Open Short Open 6 Open Short Short 7 Open Short Short 8 Short Open Open 9 Short Open Open 10 Short Open Short 11 Short Open Short 12 Short Short Open 13 Short Short Open 14 Short Short Short 15 (*1) Short Short Short *1 Set at factory shipment 1-2 Open Short Open Short Open Short Open Short Open Short Open Short Open Short Open Short IMPORTANT 1. Set the SCSI ID so that there are no duplicates between SCSI devices on the same SCSI bus. 2. The priority of SCSI bus use in ARBITRATION phase is determined by SCSI ID as follows: 7 > 6 > 5 > 4 > 3 > 2 > 1 > 0 > 15 > 14 > 13 > 12 > 11 > 10 > 9 > 8 5.3.2 Each mode setting (MP model only) (1) Setting terminal power supply Refer to Table 5.2 for controlling the supply of power from the drive to the SCSI terminal resistance power source (TERMPOW). For information on MP model, refer to Figures 5.2 and 5.3. Table 5.2 Setting SCSI terminal power supply (MP model only) Supply on/off of SCSI terminating resistor power from IDD Supply off Supply on *1 Setting at factory shipment CN2 23-24 Open Short (*1) C141-E128-01EN 5 - 7
![](/manual_guide/products/fujitsu-man3184mc-manualuser-guide-f860562/81.png)