Fujitsu MAN3735MC Manual/User Guide - Page 9
C141-E128-01EN, Alert message, Mounting Installation, ESD Electrostatics Discharge may cause
![]() |
View all Fujitsu MAN3735MC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Task Mounting Installation Alert message Page protection fuse of the terminating resistor power supplier may be blown or the cable may be burnt if overcurrent protection is not provided. When the recommended parts listed in Table 4.2 are used, inserting the cables in the wrong direction can be prevented. 2. To connect SCSI devices, be careful of the connection position of the cable. Check that the SCSI device with the terminating resistor is the last device connected to the cable. Data loss 6-4 When the SEND DIAGNOSTIC command terminates with the CHECK CONDITION status, the INIT must collect the error information using the REQUEST SENSE command. The RECEIVE DIAGNOSTIC RESULTS command cannot read out the error information detected in the self-diagnostics. Caution 6-5 1. To avoid shocks, turn off the power before connecting or disconnecting a cable, connector, or plug. 2. To avoid injury, do not touch the mechanical assembly during disk drive operation. 3. Do not use solvents to clean the disk drive. Caution 6-6 1. Always ground yourself with a wrist strap connected to ground before handling. ESD (Electrostatics Discharge) may cause the damage to the device. 2. To prevent electrical damage to the disk drive, turn the power off before connecting or disconnecting a cable, connector, or plug. 3. Do not remove a PCA. This operation is required to prevent unexpected or unpredictable operation. 4. Do not use a conductive cleaner to clean a disk drive assembly. 5. Ribbon cables are marked with a colored line. Connect the ribbon cable to a cable connector with the colored wire connected to pin 1. Damage 6-6 Do not open the DE in the field because it is a completely sealed room. Data loss 6-7 Save data stored on the disk drive before requesting repair. Fujitsu does not assume responsibility if data is destroyed during servicing or repair. Caution 6-15 Never open the disk enclosure in the field. Opening the disk enclosure in the field may cause an irreparable fault. C141-E128-01EN vii
![](/manual_guide/products/fujitsu-man3184mc-manualuser-guide-f860562/9.png)