Garmin RINO 110 Owner's Manual - Page 98
Interface Information, NMEA 0183 Version 3.0 Approved Sentences, GARMIN Proprietary Sentences - and easy gps
UPC - 753759031947
View all Garmin RINO 110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
APPENDIX > INTERFACE INFORMATION Interface Information Interface formats are selected in the Setup Interface Page. See also the "Transferring MapSource Data" section of this Appendix for information on using the Rino 110 with MapSource. The input/output lines on your Rino 110 unit are RS-232 compatible, allowing easy interface to a wide range of external devices, including PC's, differential beacon receivers, marine autopilots, and /or a second GPS receiver. The NMEA 0183 version 3.0 interface format is supported by the Rino 110 and enables the unit to drive up to three NMEA devices. NMEA 0183 Version 3.0 Approved Sentences: GPGGA, GPGLL, GPGSA, GPGSV, GPRMB, GPRMC, GPRTE, GPVTG, GPWPL, GPBOD GARMIN Proprietary Sentences: PGRME (estimated error), PGRMM (datum string), PGRMZ (altitude), PSLIB (beacon receiver control) DGPS (Differential GPS) corrections are accepted in RTCM-SC-104 version 2.0 format through the Data IN line. The Garmin GBR 21 and GBR 23 are the recommended beacon receivers for use with the Rino 110. Other beacon receivers with the correct RTCM format may be used, but may not correctly display status or allow tuning control from the GPS unit. The Rino 110 may be hard-wired to a serial connector using a Data Only Cable. Refer to the wiring diagram and the Rino 110 unit data connection illustrated below. The PC Interface Cable provided with this unit allows you to connect your Rino 110 to a PC-compatible computer's serial port. 92 Rino® 110 Owner's Manual