Garmin Zumo 660 Owner's Manual - Page 42
Changing the Fuse, About GPS Satellite Signals, Mounting on Your Dashboard, Mounting on Your - gps manual
UPC - 753759085087
View all Garmin Zumo 660 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Appendix • Do not leave your zūmo in direct sunlight. Avoid prolonged exposure to excessive heat. Changing the Fuse Caution: When replacing the fuse, do not lose any of the small pieces, and ensure they are put back in the proper place. If your unit does not charge in your vehicle, you may need to replace the fuse located at the tip of the automotive adapter. 1. Unscrew the black, round end piece, and remove it. 2. Remove the fuse (glass and silver cylinder), and replace with a 3A fast-blow fuse. 3. Ensure that the silver tip is placed in the black end piece. Screw on the black end piece. End piece Silver tip Fuse About GPS Satellite Signals Your zūmo must acquire GPS (Global Positioning System) satellite signals to navigate. If you are indoors, near tall buildings or trees, or in a parking garage, your zūmo cannot acquire satellites. Go outside to an area free from tall obstructions to use your zūmo. When your zūmo has acquired satellite signals, the signal strength bars on the Menu page are green . When it loses satellite signals, the bars turn red or clear . For more information about GPS, go to www.garmin.com/aboutGPS. Mounting on Your Dashboard Use the enclosed mounting disk to mount your unit to the dashboard and comply with certain state regulations. Caution: The permanent mounting adhesive is extremely difficult to remove after it is installed. 1. Clean and dry the dashboard where you are placing the disk. 2. Remove the backing from the adhesive on the bottom of the disk. 3. Place the disk on the dashboard. 4. Remove the clear plastic cover from the top of the disk. 5. Place the suction cup mount on top of the disk. Flip the lever down (toward the disk). 40 zūmo 600 Series Owner's Manual