Garmin Zumo 660 Owner's Manual - Page 9
Mounting Your zūmo on a Motorcycle, Step 1: Connecting Power to the, Step 2: Installing the Handlebar
UPC - 753759085087
View all Garmin Zumo 660 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Mounting Your zūmo on a Motorcycle Warning: Incorrectly wiring the power cable with bare wire leads can result in damage to the vehicle or the battery and can cause bodily injury. Garmin strongly recommends having an experienced installer with the proper knowledge of electrical systems install the unit. Step 1: Connecting Power to the Mount Select a suitable and secure location to mount the zūmo on your motorcycle based on available power sources and safe cable routing. Step 2: Installing the Handlebar Base The zūmo includes parts for two handlebar installation solutions. Custom mounts can require additional hardware (www.ram -mount.com). A) To install the U-bolt and handlebar base: 1. Place the U-bolt around the handlebar, and thread the ends through the handlebar base. 2. Tighten the nuts to secure the base. Do not overtighten. Note: The recommended torque is 50 lbf-in. Do not exceed torque of 80 lbf-in. Cradle Headphone/audio out jack (3.5 mm) Power cable Bare wires with inline fuse for power connection Handlebar base U-bolt Microphone jack (2.5 mm) Mini-USB connector (for traffic receiver) Handlebar zūmo 600 Series Owner's Manual Getting Started B) To install the handlebar base to the clutch/brake clamp bracket: Note: Both 1/4" standard and M6 bolts are included. Match the size of the factory bolts on your clutch/brake clamp bracket. 1. Remove the two factory bolts on your clutch/brake clamp bracket. 2. Thread the new bolts through the handlebar base, spacers, and clamp bracket. 3. Tighten the bolts to secure the base. Handlebar base Clutch/brake clamp bracket Spacers