Gateway E-9425R Gateway E-9425R Server User Guide - Page 37
Installing and removing drives, Removing and installing an optical drive
![]() |
View all Gateway E-9425R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
www.gateway.com 4 Replace the screw (2) to hold the rear top cover in place. 5 Reconnect the power cord(s) and all other cables. Installing and removing drives Your server's basic configuration includes one optical drive and as many as four SATA or SAS hot-swap hard drives. An optional diskette drive can also be added in place of the hard drive on the left side of the server. As you prepare to install drives, remember: • You must install the optional diskette drive in the left converted hard drive bay. • Before you install a drive, see the drive's documentation for information on configuring the drive, setting drive jumpers, and attaching cables. • You may need to configure the drives you install using the BIOS Setup utility. Press F2 at startup to open the BIOS Setup utility. Removing and installing an optical drive To remove and install an optical drive: Caution The optical drive is not hot-swappable. Before installing or removing the drive, make sure that power is turned off and the power cord is unplugged. 1 Follow the instructions in "Preventing static electricity discharge" on page 28. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server. 2 Unlock the bezel (if necessary) and remove it by pulling it from the chassis. 3 Follow the instructions in "Opening the server case" on page 29. 4 Disconnect the 44-pin optical drive cable from the optical drive interface board. 31
![](/manual_guide/products/gateway-computers-e9425r-gateway-e9425r-server-user-guide-a06fbd8/37.png)