Gateway E-9425R Gateway E-9425R Server User Guide - Page 38

Installing Components, Important

Get Gateway E-9425R PDF manuals and user guides View all Gateway E-9425R manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

CHAPTER 4: Installing Components 5 Loosen the thumbscrew (1) holding the retaining clip (2) against the side of the optical drive, then move the retaining clip away from the drive. Important The hard drive carriers shown in these illustrations may look different than the actual hard drive carriers in your server. 6 Push the optical drive to the right to release the drive from the drive bay, then pull the drive out of the bay. 7 Unscrew the two screws holding the optical drive interface board on the back of the optical drive, then remove it. 8 Using the two screws you just removed, attach the optical drive interface board to the back of the new optical drive. 32

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
CHAPTER 4: Installing Components
32
5
Loosen the thumbscrew (1) holding the retaining clip (2) against the side of the optical drive,
then move the retaining clip away from the drive.
6
Push the optical drive to the right to release the drive from the drive bay, then pull the drive
out of the bay.
7
Unscrew the two screws holding the optical drive interface board on the back of the optical
drive, then remove it.
8
Using the two screws you just removed, attach the optical drive interface board to the back
of the new optical drive.
Important
The hard drive carriers shown in these illustrations may look different than
the actual hard drive carriers in your server.