Gateway E-9722R Gateway E-9722R Server User Guide - Page 55
Replacing the control panel, Replacing the system board
View all Gateway E-9722R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
www.gateway.com Replacing the control panel Caution Your server must be operated with a control panel in place. To replace the control panel adapter card: 1 Follow the instructions in "Preventing static electricity discharge" on page 24. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server. 2 Follow the instructions in "Opening the server case" on page 25. 3 Disconnect all cables from the control panel. 4 Press down the two side locking tabs, then pull the control panel back and lift it out of the chassis 5 Holding the new control panel by the edges, align it with the locking tabs in the chassis, then slide it toward the front of the chassis. 6 Reconnect the cables to the control panel. 7 Follow the instructions in "Closing the server case" on page 27. Replacing the system board To replace the system board: 1 Follow the instructions in "Preventing static electricity discharge" on page 24. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server. 2 Follow the instructions in "Opening the server case" on page 25. 3 Remove the PCI riser assembly by following the instructions in "Installing and removing PCI expansion cards" on page 34. 4 Remove the fan duct and system fan cage by following the instructions in "Replacing system fans" on page 38. 5 Remove the memory modules by following the instructions in "Installing memory" on page 31. 6 Remove the heatsinks and processors by following the instructions in "Replacing or adding a processor" on page 41. 7 Disconnect all cables from the system board, noting their locations and orientation. (You will reconnect the cables after you install the new board.) 49