GE NX-148E User Manual - Page 10

ARMING YOUR SYSTEM IN THE "STAY" MODE STAY is utilized when the user is inside the premise and wants protection around the perimeter. The steps to arm in the STAY Mode are as follows: Step 1 Close all protected doors and windows. Ready light must be on or flashing (force armed) when all protected zones and sensors are secure. NOTE: If any zones are bypassed, a sensor in that zone can be violated without affecting the ready light. The security system will not arm if the ready light is not on or flashing. If the power light is off, you have no AC power. Restore power if possible. If not, contact the installing company for service. System Ready Type code to arm Step 2 Enter your 4 or 6 digit user code. (Optional, if programmed.) If "Auto Bypass" is enabled, all interior zones will be bypassed if you do not leave through a designated entry/exit door. If Auto Bypass is enabled, omit Step 3. When "Auto Instant" is enabled, if you do not leave through a designated entry/exit door, the display will read "Instant", indicating that the entry/exit doors no longer have an entry delay. If "Auto Instant" is enabled, omit Step 4. Step 3 Press the [STAY] key. The stay light will illuminate indicating that all interior zones are bypassed. (All interior devices will bypass automatically, giving the user freedom of movement within the interior area.) The bypass light will illuminate if any zone(s) are bypassed. If any zone (s) have been bypassed previously by the user, the light(s) corresponding to the bypassed zone(s) will illuminate, alerting the user that a zone(s) may be unprotected and can be faulted without an alarm. Step 4 To toggle from a "delayed entry" mode to an "Instant" mode, press the [STAY] key again. The LCD display will read "Instant" meaning the entry/exit doors do NOT have an entry System Armed Instant delay. 8 NX-148E-CF