GE NX-148E User Manual - Page 8

UNDERSTANDING THE LIGHTS Armed Light The armed light is "on" when the system is armed. The armed light is "off" when it is disarmed. The armed light will flash when there has been an alarm during the previous arm cycle. Bypass Light The bypass light is "on" when any zone in this keypad's partition is bypassed. If the bypass light is "off", no zones are bypassed. Cancel Light The cancel light will flash during an abort delay time. Entering a code followed by the [CANCEL] key during or after an alarm report to the central station will cause the cancel light to come on. It will stay on until the central station has received the cancel report. NOTE: The cancel feature must be enabled. (See "Cancel/Abort Feature" on page 10.) Chime Light The chime light is "on" when the chime feature is "on"; "off" otherwise. Exit Light The exit light is "on" during the exit delay. Please note that the light will flash during the last 10 seconds of the exit delay as a warning that the time is running out. (The user may want to disarm the system if the exit light is flashing in order to prevent an alarm. The user may then re-arm the system and exit before the delay expires.) Fire Light A steady fire light means a fire zone has been faulted. A rapidly flashing fire light means that a fire zone is in a trouble condition. Power Light The power light is on if the primary power is on. The power light will flash if the system has a low battery condition. Ready Light The ready light is "on" when the system is ready to arm and "flashes" if ready to force arm. The ready light is "off" when the system is not ready to arm because of a zone(s) being faulted. Stay Light The stay light is illuminated when all interior zones are bypassed. Instant Message The LCD display will read "Instant" when the entry/exit door(s) have no delay. (See "Arming System in Stay Mode", page 8.) The doors can be changed from instant to delay (toggled) by pressing the [STAY] key when the system is armed. 6 NX-148E-CF