Genie Excelerator Owner's Manual - Page 11

NOTE • Loosen (Do Not Remove) Terminal Block Screws. • Limit Switch adjustments and securing the Wires will be done later. F Lay Wires in channel on top of Rail and secure with Wire Clips (Figure 14). G Coil and bundle excess Limit Switch Wires on top of Power Head with Twist Ties. Leave just enough Wire to reach Terminals on back of Power Head (Figure 14). H Turn Opener upside down, and connect Limit Switch Wires to Power Head Terminal Block (Figure 15): • Terminal 4: OPEN Limit Switch Wire (white). • Terminal 5: OPEN Limit Switch Wire (white) and CLOSE Limit Switch Wire (brown). • Terminal 6: CLOSE Limit Switch Wire (brown). Antenna Terminal Block White Limit Brown Limit Switch wires Switch wires Figure 15 Connect Limit Switch Wires to Power Head Terminal Block Assembly Step C7H: ATTACH EMERGENCY RELEASE KNOB, CORD, AND TAG A Tie overhand knot at one end of Emergency Release Cord. B Thread opposite end of Cord through Knob and hole in Magnetic Carriage Assembly Release Lever (Figure 16). C Tie overhand knot at this end of Emergency Release Cord. D Attach Emergency Release Tag to Magnetic Carriage Assembly Release Lever. 25 Emergency Release Tag Assembly Step C8H: RECORD OPENER MODEL AND SERIAL NUMBER Please note the following information so it is available if you need to call us: Date purchased: Serial number (Figure 17): Model number (Figure 17): Dealer Name: Dealer Address: City: State: Zip: Phone: Emergency Release Knob 24 Figure 16 Attach Emergency Release Cord/Knob and Tag Model Number NOTE Please keep original or photocopy of your sales receipt with this manual for future reference should service ever be required. Serial Number (example) Figure 17 Model and Serial Numbers For Help, call 1-800-35-GENIE or visit www.geniecompany.com 11